Digilent Robotic Development Kit - Remote Manuel d'utilisateur télécharger pdf (Page 6)

Remote Control Robotic Development Kit Reference Manual

www.digilentinc.com page 6 of 9

9. Connect the two PmodHB5 modules to port JD on the Cerebot 32MX4 board using the 2x6 Pin

to dual 6 pin cable. Use the marker on the cable connector to ensure that pin placements are

in alignment when connecting the boards.

10. Strip ½-inch of insulation from both ends of all red and black 22 gauge power wires.

1 2 3 4 5 6 7 8 9

Pas de commentaire

Digilent Robotic Development Kit - Remote Manuel d'utilisateur Page 6