Digilent Robotic Development Kit Manuel d'utilisateur télécharger pdf (Page 5)

Line Sensor Robotic Development Kit Reference Manual

www.digilentinc.com page 5 of 9

8. Compare the Cerebot MX4cK board to the picture below. Note that the blue shorts are

attached to each jumper as depicted. Remove the rubber feet from the bottom of the corners

of the Cerebot MX4cK. Attach the standoffs to the board using the corresponding mounting

screws. Mount the Cerebot MX4cK board to the top side of the metal platform. Be careful not

to cross thread screws while mounting the Cerebot MX4cK Board.

Note: The Cerebot 32MX4 can also be used with this procedure.

1 2 3 4 5 6 7 8 9

Pas de commentaire

Digilent Robotic Development Kit Manuel d'utilisateur Page 5